CIB-BA-e-2010 13
6 Unpacking, Setup and Commissioning
6.1 Installation Site, Location of Use
The balances are designed in a way that reliable weighing results are achieved in
common conditions of use.
You will work accurately and fast, if you select the right location for your balance.
On the installation site observe the following:
• Place the balance on a firm, level surface.
• Avoid extreme heat as well as temperature fluctuation caused by installing next
to a radiator or in direct sunlight.
• Protect the balance against direct draughts due to open windows and doors.
• Avoid jarring during weighing.
• Protect the balance against high humidity, vapours and dust.
• Do not expose the device to extreme dampness for longer periods of time.
Non-permitted condensation (condensation of air humidity on the appliance)
may occur if a cold appliance is taken to a considerably warmer environment.
In this case, acclimatize the disconnected appliance for approx. 2 hours at
room temperature.
• Avoid static charge of goods to be weighed or weighing container.
• Do not operate in areas with hazard of explosive material or in potentially
explosive atmospheres due to materials such as gasses, steams, mists or
dusts.
• Keep away chemicals (such as liquids or gasses), which could attack and
damage the balance inside or from outside.
If electro-magnetic fields or static charge occur, or if the power supply is unstable,
major deviations on the display (incorrect weighing results) are possible. In that case,
the location must be changed.
6.2 Unpacking, Scope of delivery
Remove device and accessories carefully from packaging, remove packaging material
and place device at the planned work place. Check if that there has been no damage
and that all packing items are present.
Scope of delivery / serial accessories
To Next Page
Loading...
Need help?
General
