The balance returns to the < Errupp > menu.
Use the navigation keys to select the setting <
errlow> and confirm on [ ] button.
Use the navigation keys to select the weighing unit
and confirm on [ ] button.
The numeric input window appears. The active digit is
flashing.
Enter the lower tolerance (for numerical input, see
chap. 3.2.2) and confirm the entry.
The balance returns to the < Errlow > menu.
Press repeatedly button to exit menu.
Finished the setting works, the weighing balance will be
ready for target counting.
2. Start tolerance check:
Determine the average piece weight, see chap. 12.2.1
Place the weighed material and check by means of the tolerance marks / acoustic
signal if the weighed material is within the defined tolerance.
Load below specified
tolerance
Load within specified
tolerance
Load exceeds specified
tolerance
The entered values will remain valid until new values are entered.
To delete the values, select menu setting < target > < clear >
and confirm on [ ] button.
To Next Page
Loading...
Need help?
General
