KERN PCB - Change-Over Button (Standard Settings)

26 TPCB-A-BA-e-2314
8.5 Change-over button (standard settings)
The change-over button can be allocated with different functions.
The following functions are set as per standard (<default>) in the different
weighing applications:
Short key pressing
Long key pressing
Weih
➢ When pressed for first time:
Setting weighing unit
➢ Switch-over between the
weighing units
➢ Display gross weight value
count
➢ When pressed for first time:
Setting the reference quantity
➢ Switch-over between the
weighing units
➢ When the balance has been tared
and the weighing unit is displayed,
you can change the display
between gross weight, net weight
and tare weight by pressing the
button long time.
check
➢ When pressed for first time:
Setting weighing unit
➢ Switch-over between the
weighing units
➢ When the balance has been tared
and the weighing unit is displayed,
you can change the display
between gross weight, net weight
and tare weight by pressing the
button long time.
For more setting options please see the setup menu under < buttons >,
see chap. 13.3.1.
The standard settings (<default>) for the <Weighing> application are described
below.