KERN PCB - Page 3

TPCB-A-BA-e-2314 3
7.9.1 External adjustment < CalExt > ................................................................19
7.9.2 External adjustment with user-defined adjustment weight < caleud > .......20
7.9.3 Gravitational constant adjustment location < graadj > ..............................22
7.9.4 Gravitational constant place of location < grause > ...................................23
8 Basic Operation ............................................................................................... 24
8.1 Turn on/off ................................................................................................... 24
8.2 Simple weighing .......................................................................................... 24
8.3 Zeroing ........................................................................................................ 25
8.4 Taring .......................................................................................................... 25
8.5 Change-over button (standard settings) ...................................................... 26
8.5.1 Switch-over weighing unit ................................................................................27
8.5.2 Display gross weight value ..............................................................................28
8.6 Underfloor weighing ..................................................................................... 29
9 Operating concept ........................................................................................... 30
10 Application <Weighing> ............................................................................... 32
10.1 Application-specific settings ..................................................................... 32
10.2 PRE-Tare ................................................................................................. 33
10.2.1 Take over the placed weight as PRE-TARE value ...........................................33
10.2.2 Enter the known tare weight numerically .........................................................34
10.3 Data-Hold function ................................................................................... 34
10.4 Weighing Units ......................................................................................... 35
10.4.1 Setting weighing unit .......................................................................................35
10.4.2 Weighing with multiplication factor via the application unit <FFA> ...................36
10.4.3 Percent weighing by application unit <%> .......................................................36
10.4.4 Molar weighing mode ......................................................................................37
11 Application <Counting> ............................................................................... 38
11.1 Application-specific settings ..................................................................... 38
11.2 Using the application ................................................................................ 39
11.2.1 Piece counting.................................................................................................39
11.2.2 Target counting ...............................................................................................42
12 Application < Checkweighing > ................................................................... 45
12.1 Application-specific settings ..................................................................... 45
12.2 Using the application ................................................................................ 46
12.2.1 Target weighing ...............................................................................................46
12.2.2 Checkweighing ................................................................................................49
13 Menü .............................................................................................................. 51
13.1 Navigation in the menu............................................................................. 51