KERN PCB - Page 43

TPCB-A-BA-e-2314 43
Procedure:
1. Define target quantity and tolerances
 Make sure that the scale is in counting mode and that an
average piece weight has been defined (see chap. 11.2.1).
If necessary, switch over with the button.
 Use the navigation keys  to select the setting < tar-
get > and confirm with ➔ button.
< value > is displayed.

 Confirm on ➔ button, the numeric input window appears.
The active digit is flashing.
 Enter the target quantity (numerical input see chap. 3.2.2)
and confirm the entry.
The balance returns to the < value > menu.
 Use the navigation keys  to select the setting < Er-
rupp> and confirm on ➔ button.
 Use the navigation keys  to select the weighing unit and
confirm on ➔ button.


 The numeric input window appears. The active digit is
flashing.
 Enter the upper tolerance (for numerical input see chap.
3.2.2) and confirm the entry.
The balance returns to the < Errupp > menu.