Save/Recall (Setups, Screens, Data) 18
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide 235
To save reference waveform files to a USB storage device
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press the Save softkey.
3 In the Save Menu, press the Format softkey and turn the Entry knob to select
Reference Waveform data (*.h5) .
4 Press the Source softkey and turn the Entry knob to select the source waveform.
5 Press the softkey in the second position and use the Entry knob to navigate to
the save location. See “To navigate storage locations" on page 236.
6 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
To save masks
Mask files can be saved to one of four internal (\Keysight Flash) locations or to an
external USB storage device.
1 Press [Save/Recall] > Save > Format; then, turn the Entry knob to select Mask
(*.msk).
2 Press the softkey in the second position and use the Entry knob to navigate to
the save location. See “To navigate storage locations" on page 236.
3 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
Mask files have the extension MSK.
See Also • Chapter 15, “Mask Testing,” starting on page 201
Masks are also saved as part of setup files. See “To save setup files" on page 231.
To Next Page
Loading...
Need help?
General
