288 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
22 Reference
For information about upgrading your oscilloscope through licensing, contact your
local Keysight Technologies representative or see
www.keysight.com/find/2000X-Series.
Software and Firmware Updates
From time to time Keysight Technologies releases software and firmware updates
for its products. To search for firmware updates for your oscilloscope, direct your
web browser to www.keysight.com/find/2000X-Series-sw.
To view the currently installed software and firmware press [Help] > About
Oscilloscope.
Once you have downloaded a firmware update file, you can place it on a USB
storage device and load the file using File Explorer (see “File Explorer" on
page 251), or you can use the Instrument Utilities page of the oscilloscope's web
interface (see “Instrument Utilities" on page 278).
Binary Data (.bin) Format
The binary data format stores waveform data in binary format and provides data
headers that describe that data.
Because the data is in binary format, the size of the file is approximately 5 times
smaller than the ASCII XY format.
If more than one source is on, all displayed sources will be saved, except math
functions.
When using segmented memory, each segment is treated as a separate
waveform. All segments for a channel are saved, then all segments of the next
(higher numbered) channel are saved. This continues until all displayed channels
are saved.
When the oscilloscope is in the Peak Detect acquisition mode, the minimum and
maximum value waveform data points are saved to the file in separate waveform
buffers. The minimum value data points are saved first; then, the maximum value
data points are saved.
To Next Page
Loading...
Need help?
General
