Keysight Technologies J7201A - Page 61

Remote Operations 6
Keysight J7201A/B/C Operating and Service Manual 61
Examples
To query the number of cycles:
DIAGnostic:RELay:CYCLes? (@1:8)
[INPut:]ATTenuation:AUTOcorrected/INPut[:ATTenuation]:AUTOcorrected
Sets the instrument operating mode: 0 for normal mode, 1 for auto mode.
[INPut:]ATTenuation:AUTOcorrected <bool>
Examples
To set the instrument operating mode to auto mode:
[INPut:]ATTenuation:AUTOcorrected 1
To query the set instrument operating mode:
[INPut:]ATTenuation:AUTOcorrected?
Related Commands
CORRection?
CORRection:AUTO?
CORRection?
Enables you to query the corrected value. The first parameter specifies the attenuation
level. The second parameter is the frequency. If no parameter passed in, then the current
corrected value will be returned.
CORRection? [<atten_level>][<suffic>],[<frequency>][<suffic>]
Maximum 108
Units None
Query? Yes
Set? Yes
Set/Return Parameters Boolean Data: 0|1
Minimum n/a
Maximum n/a
Units n/a
Query? Yes, query only
Set? No
Return Parameters
Numeric representation format: Double Digit
Integer (for example, 8)
Minimum
0 dB – for attenuation level
0 Hz – for frequency