Keysight N5991 Test Automation Software Platform Getting Started Guide 43
Using the Software 5
Table 1 Sequencer Parameters
Common Parameters
The common parameters are used for several related calibration or test
procedures. They are shown on the right side of the ValiFrame user
interface when the selected entry of the procedure tree on the left is a
group instead of an individual procedure.
Procedure Parameters
The Procedure Parameters are all parameters that do not fall into one of
the previously described categories. They are shown on the right side of
the ValiFrame user interface when the selected entry of the procedure tree
on the left is an individual procedure. They only change the behavior of
that single procedure. Procedures often have parameters with the same
name, but set settings always apply on the selected procedure, and the
meaning may be slightly different.
Running Procedures
To run the selected procedures, press the START button. The procedures
are run in the order, shown in the procedure selection tree. Some
procedures may require user interaction such as changing cable
connections or entering DUT parameters. The required action is prompted
in pop-up dialog boxes prior to the execution as shown in Figure 23:
Parameter Parameter Description
Procedure Error Case Behavior “Proceed With Next Procedure”: If an error occurs in the current test or calibration procedure,
continue by running the next procedure in the sequence.
“Abort Sequence”: Abort the execution of the sequence.
Procedure Failed Case Behavior “Proceed With Next Procedure”: If the current test or calibration procedure fails, continue by
running the next procedure in the sequence.
“Abort Sequence”: Abort the execution of the sequence.
Repetitions The number of times the group or procedure is going to be repeated. If the value is '0', it runs only
once.
To Next Page
Loading...
Need help?
General
