Keysight CX3300 Series - Page 103

Keysight CX3300 User’s Guide, Edition 4 103
Safety Information
Safety Summary
• DANGEROUS PROCEDURE WARNINGS
Warnings, indicated by red WARNING mark, shall be complied. Procedures
throughout in this manual prevent you from potential hazard. Their
instructions contained in the warnings must be followed.
• BEFORE APPLYING POWER
Verify that all safety precautions are taken. Note the instrument's external
markings described under “Safety Symbols”.
• GROUND THE INSTRUMENT
This is Safety Class I instrument. To minimize shock hazard, the instrument
chassis and cabinet must be connected to an electrical ground. The power
terminal and the power cord must meet International Electrotechnical
Commission (IEC) safety standards.
• DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the presence of flammable gases, corrosive
gases, o
r fumes. Operation of any electrical instrument in such an
environment constitutes a definite safety hazard.
• DO NOT REMOVE COVERS
No operator serviceable parts inside. Refer servicing to qualified personnel.
To prevent electrical shock do not remove covers.
• IN CASE OF DAMAGE
Instruments that appear damaged or defective should be made inoperative
and secured against unintended operation until they ca
n be repaired by
qualified service personnel. Return the instrument to a Keysight Technologies
sales or service office for services and repair to ensure that safety features are
maintained.
• USE ONLY THE SPECIFIC ACCESSORIES
Specific accessories satisfy the requirements for specific characteristics for
using the instrument. Use the specific accessories, cables, adapters, and so
on for safety reasons
.