Keysight CX3300 Series - Setting the CX3300 for an Edge Trigger

58 Keysight CX3300 User’s Guide, Edition 4
Using the CX3300
Setting Up Triggers
Setting the CX3300 for an Edge Trigger
1. Press the Source key until the desired source LED is lit.
You can choose any of the channels or the Aux Trig or Line input as the source
for an edge trigger.
2. Press the
Slope key until the desired slope LED is lit.
You can have an edge trigger on a rising or falling edge, or both.
3. Press the
Sweep key until the desired LED is lit (Trig’d or Auto).
When Trig’d is selected, the CX3300 must find the trigger before capturing
and displaying data.
When
Auto is selected, if a trigger does not occur within a certain amount of
time, an acquisition is automatically saved and displayed. In Auto trigger
mode, you are able to see your signals while setting up the desired trigger.
4. Turn the Level knob to adjust the current or voltage level at which the
CX3300 will trigger.
You can also drag the trigger level indicator at the left side of the display to
adjust the level. See Figure 2-4 for the trigger level indicator.
Pressing the knob changes the trigger level to half.