Keysight CX3300 Series - Adjusting the Vertical Settings

54 Keysight CX3300 User’s Guide, Edition 4
Using the CX3300
Adjusting the Vertical Settings
Adjusting the Vertical Settings
Use the Vertical control to set the vertical scale (amperes per division or volts
per division) and the vertical offset and to magnify the waveform.
To adjust the vertical scale and the vertical offset, use the vertical control knobs
or the Setting dialog box (Setting > Channels > Channel N, where N is 1, 2, 3, or
4).
This dialog box is opened by clicking the Setting icon on the sidebar or
pressing the
Menu key located above the Horizontal control on the front panel.
To change
channel status
To enable or disable the analog input channel, press the # key (#: 1, 2, 3, or 4)
associated with the channel.
Pressing the # key changes the channel status as shown below.
Graph displays the waveforms for the channels in the ON
status.
Vertical control and graph scaling are effective only for the channel indicated by
the LED which lights (ON).
Scale
Position (offset)
Zoom
Analog input channel 1
Analog input channel 2
Analog input channel 3
Analog input channel 4
LED
other # key# key
other # key # key
other # key
# key
OFF OFF
#
ON ON
#
ON OFF
#