50 Keysight CX3300 User’s Guide, Edition 4
Using the CX3300
Setting the Display and the Starting Condition
Setting the Display and the Starting Condition
The following keys are available for setting up the CX3300 display and starting
condition quickly. They are located in the Horizontal control on the front panel.
• To automatically set up the CX3300 for the present input signal(s), press the
Auto Scale key. Auto scaling is applied to the waveform supported by the graph
scale.
• To enable/disable the high resolution mode of acquisition, press the
High Reso
key. Enabling the mode automatically reduces sampling rate and memory
depth to get clean waveforms. The
High Reso key is lit when the mode is
effective.
• To clear waveform on the graph, press the
Clear Display key.
The CX3300 clears acquired waveform data from the graph in preparation
for
another acquisition. If the CX3300 is in Run mode and is receiving triggers, it
will update the graph as it collects new waveform data.
Clearing the waveform also clears the analysis graph and data.
• To apply the default setup, press the
Default Setup key.
To enable/disable the touch screen, press the
Touch Panel key located in the lower
right corner on the front panel. The indicator is lit green when the touch panel
operation is effective.
For setting up the CX3300 quickly, you can reuse the saved acquisition setup. To
reuse the setup, click the Load icon on the sidebar. For saving the setup, see
“Saving and Printing Data” on page 80.
To Next Page
Loading...
