Keysight CX3300 Series - Page 40

40 Keysight CX3300 User’s Guide, Edition 4
Using the CX3300
Front Panel Overview
3. Analog input channels
The CX3322A has two channels and the CX3324A has four channels.
Connects the CX1100 other than the CX1152A. See “Connecting the CX1100”
on page 21. Also refer to CX1100 User’s Guide for the CX3300 accessories.
CAUTION
Confirm the maximum rating of the accessories. Do not apply any electrical
potential and/or current over the value.
4. Three USB 2.0 host ports
Used to connect USB devices such as keyboard, mouse, and USB memory.
To remove USB devices from the instrument, use “Safely Remove Hardware”
on Windows taskbar. If it is not used, the instrument may cause the internal
USB communication error. If the error occurs, turn the instrument off and
disconnect the power cord from it. Leave it about 30 seconds before
rebooting it, and connect the power cord again
, and then turn the instrument
on.
5. Touch Panel switch
Works when the CX3300 application is running. Enables or disables the
touch screen operation. The green LED lights when the touch screen is
enabled.
6. Vertical control
Controls analog input channel and graph scale. See “Adjusting the Vertical
Settings” on page 54.
7. Trigger control
Controls trigger condition. See “Setting Up Triggers” on page 57.
8. Horizontal control
Cont
rols timebase and graph scale. See “Adjusting the Horizontal Scale and
Timebase Position” on page 52.
9. Run Control
Controls measurement execution. See “Starting and Stopping Waveform
Acquisitions” on page 51.
10. Navigation keys (up, down, left, right, and enter)
