Chapter 6: Replacing Assemblies
To replace the Intel motherboard with the ADLINK motherboard
127
18
Pull back the Front Panel USB cover label and replace the old D8104- 61602
USB cable with the new D8104- 61608 cable.
19 Route cables though the chassis holes to prepare to reattach the front Panel
assembly to the frame
20 Re- install the Front Panel with four Torx T15 screws that secure the chassis
sides to the front panel assembly. Torque the screws to 18 in- lb.
21 Using a 9/16" nut driver, install the five hex nuts that secure the BNC connectors
to the front panel. Put the conical side of the nut toward the front- panel casting.
Torque the hex nuts to 18 in- lb.
22 Reattach the AutoProbe to the mylar flex cable and pop the board back into place.
23 Using the new Motherboard Deck and new Motherboard:
24 Install the six 5 mm port lock screws securing the rear panel connectors.
To Next Page
Loading...
