Keysight Infiniium MSOS404A Service Guide

19
Keysight Infiniium S-Series Oscilloscopes
Service Guide
3 Testing Performance
Performance Verification General Information 20
Vertical Performance Verification 21
Input Impedance Test 22
Offset Accuracy Test 24
DC Gain Accuracy Test 31
Analog Bandwidth—Maximum Frequency Test 34
Time Scale Accuracy (TSA) Test 41
Performance Test Record 44
Full performance verification for the S-Series oscilloscopes consists of three main
procedures:
1 Performing the internal oscilloscope self-tests to ensure that the measurement
system is functioning properly. To perform the self-tests, click Utilities > Self
Test.... Then select Scope SelfTest from the Available Self Test drop-down list
box, click Start, and follow the on-screen instructions. If any of the self tests fail,
ensure that the failure is diagnosed and repaired before calibrating and testing
performance.
2 Calibrating the oscilloscope, as described in Chapter 2.
3 Testing the oscilloscope to ensure that it is performing to specification. This
chapter describes these performance test procedures.

Keysight Infiniium MSOS404A Specifications

General

Brand	Keysight
Model	Infiniium MSOS404A
Category	Test Equipment
Language	English