4.
Use the kcos networking ip show command to return the system's IP address as follows:
Note: If your network does not have a DHCP service available, configure a static IP address, as
described in the next section.
Method 2: Configure static IP
If you are not using DHCP-based IP addressing, you will need to configure a static IP address. Static IP
configuration requires that you use the RS232 port or the keyboard.
To configure the static IP address, do the following on the UHD100T32 KCOS console:
1.
Open the serial connection from your terminal emulation application.
The KCOS console prompts you to sign in.
Chapter 4 How do I...
913-2626-01 – 26 –
To Next Page
Loading...
