CHAPTER 5 FAQs
This section provides guidance to interpret the operational status of your UHD100T32 unit and to
troubleshoot issues that may arise.
If you need assistance, contact Keysight Technical Support by using the contact information provided
in Contact Us.
How do we know the status of ports?
The UHD100T32 fixed chassis provides LED indicators that provide a visual presentation of the
operational status of the device and its individual ports. The About UHD100T32 topic provides
complete information about LED indicators.
Which IP addresses need to be assigned?
The UHD100T32 chassis system requires a management IP address.
If your network implements a DHCP service, the UHD100T32 IP addresses are automatically assigned
by that service, unless you choose to assign a static IP address instead. When assigning static IP
addresses, you must observe the following requirement:
The address cannot be on the following subnets:
10.0.x.x/16
10.1.1.x/16
These subnets are reserved for internal chassis and card communications.
Failure to observe these requirements may result in connectivity failures.
What licensing issues can result in problems?
Following is a list of licensing issues that can result in operational problems:
l Licensing: You need a license to run UHD100T32.
l License invalidation: Time discrepancies between the <product> and UHD100T32 will invalidate
the installed licenses. For instructions, see Install licenses.
What are the TCP and UDP ports that are open?
Following is a list of TCP and UDP ports that are available in UHD100T32.
– 33 – 913-2626-01
To Next Page
Loading...
