Keysight NFA Series Noise Figure Analyzers Service Guide 481
Post-Repair Procedures
Post-Repair Procedures
Operating System Initialization
When a new disk drive is powered on for the first time the operating system
will need to initialize itself before the instrument can be used. This will take just
a few minutes to complete and will require very little user interaction.
Initialization
1. With the new disk drive installed power the instrument on.
2. Within a few seconds you will see the initial Keysight Technologies splash
screen, and then the boot selection menu as seen in Figure 16-3.
3. Allow the instrument to boot the Windows operating system. (This will
happen automatically after 5 seconds if the instrument is left alone).
Figure 16-3 Boot Selection Screen
To Next Page
Loading...
