Keysight NFA Series Noise Figure Analyzers Service Guide 485
Post-Repair Procedures
Post-Repair Procedures
5. The FPGA Programming Utility will start and a window as shown in Figure
16-6 will appear.
Figure 16-6 FPGA Programming Utility
6. To program the FPGA code enter 1 and press Enter. You will need to
confirm this selection by pressing 1 and Enter one more time.
7. The programming of the FPGA code could take a few minutes to complete.
Once it has finished the instrument will reboot itself to use the new code
and this process will then be completed.
To Next Page
Loading...
