557
Assembly Replacement Procedures
Front Frame Assembly
6. Refer to Figure 14-95. The LED board (1) can now be separated from the
LED board overlay (2).
Figure 14-95 LED Board and Overlay
Replacement
1. Refer to Figure 14-95. Line up the holes and carefully attach the overlay
(2) to the LED board (1).
2. Refer to Figure 14-94. Install the LED board with overlay attached into the
front frame.
3. Secure the LED board with two screws (2). Torque to 9 in-lbs.
4. Refer to Figure 14-91. Install the BBIQ Interface board, into the front frame
passing the BNC connectors through the holes. Secure the board with two
screws (2). Torque to 9 in-lbs.
5. Reconnect the ribbon cable to the connector on the BBIQ Interface board.
Using a ¼-inch socket reinstall the two Hex screws (1) that secure the
flex ribbon into the connector. Torque to 4 in-lbs.
6. Refer to Figure 14-92. Secure the BBIQ Interface board to the side of the
front frame with a single screw (1). Torque to 9 in-lbs.
7. Refer to Figure 14-93. Line up and carefully attach the top overlay over the
lower overlay.
8. Press firmly down over the entire surface area of the top overlay.
To Next Page
Loading...
