Keysight N9030B - Burst Width Auto Detection; Burst Width

3 Spectrum Analyzer Mode
3.7 Burst Power Measurement
Remote Command
[:SENSe]:TXPower:METHod THReshold | BWIDth
[:SENSe]:TXPower:METHod?
Example
:TXP:METH BWID
:TXP:METH?
Dependencies Only appears in Spectrum Analyzer and GSM/EDGE Modes
Preset
THReshold
State Saved Yes
Range Above Threshold Lvl|Burst Width
Backwards Compatibility
SCPI
[:SENSe]:BPOWer:METHod
Burst Width Auto Detection
Turns Burst Width Auto Detection on or off.
Remote Command
[:SENSe]:TXPower:BURSt:AUTO ON | OFF | 1 | 0
[:SENSe]:TXPower:BURSt:AUTO?
Example
:TXP:BURS:AUTO 1
:TXP:BURS:AUTO?
Preset
ON
State Saved Yes
Backwards Compatibility
SCPI
[:SENSe]:BPOWer:BURSt:AUTO
Burst Width
When "Burst Width Auto Detection" on page 1324 is OFF, you may enter a fixed-
time value in seconds, or alternatively specify the burst width as a percentage of the
last measured burst width (result in bottom-left corner of second window).
Remote Command
[:SENSe]:TXPower:BURSt:WIDTh <time>
[:SENSe]:TXPower:BURSt:WIDTh?
Example
:TXP:BURS:WIDT 10
:TXP:BURS:WIDT?
:TXP:BURS:AUTO 0
:TXP:BURS:AUTO?
Dependencies Grayed-out if "Meas Method" on page 1323 is ‘Above Threshold Lvl’
Gray-out message: ‘Settings Conflict; Meas Method must be Measured Burst Width’
1324 Spectrum Analyzer Mode User's &Programmer's Reference