Keysight N9030B - SYSTem:PERSona:MODel:DEFault; 4.2.5 LXI; 4.2.5.1 LAN Reset; 4.2.5.2 Device Identification (Remote Command Only)

4 System
4.2 I/O Config
The query returns the current value of the *IDN?MODel field
SYSTem:PERSona:MODel:DEFault
Resets the MODel field of the *IDN? response to the default value.
Remote
Command
:SYSTem:PERSona:MODel:DEFault
:SYSTem:PERSona:MODel:DEFault?
Notes The query returns the default MODel field value of *IDN? even if the current setting of *IDN? is the
non-default value. The return type is a <string>
4.2.5 LXI
Accesses various LXI configuration properties.
Dependencies Not available in UXM
4.2.5.1 LAN Reset
Resets the LAN connection. This sets parameters as follows, and restarts the LAN
operation:
DHCP Enabled
Automatic IP Address Enabled
ICMP Ping Responder Enabled
Web Password
keysight
Dynamic DNS Enabled
mDNS and DNS-SD Enabled
Dynamic Link Local Addressing Enabled
Auto Negotiation Enabled
There is no SCPI command for this function.
4.2.5.2 Device Identification (Remote Command Only)
Enabling LXI device identification places the LXI Status Indicator in the Identify
state. Disabling LXI device identification places the LXI Status Indicator in the No
Fault state. The LXI Status indicator is in the upper left region of the instrument’s
graphical user interface.
Remote Command
:LXI:IDENtify[:STATe] OFF | ON | 0 | 1
Spectrum Analyzer Mode User's &Programmer's Reference 2062