3 Spectrum Analyzer Mode
3.11 Harmonics Measurement
User View Listing Query
Returns a string containing a comma-separated list of names for only the User
Views available for the current Measurement.
Remote
Command
:DISPlay:VIEW:ADVanced:USER:CATalog?
Example
:DISP:VIEW:ADV:USER:CAT?
Notes Returns a quoted string of the available User Views for the current measurement, separated by
commas.
Example:
"Baseband,myView1,yourView1"
If you switch measurements with the display disabled (see "Display Enable (Remote Command Only)"
on page 2004), then query the list of available Views, the result is undefined
3.11.6 Frequency
Contains controls that allow you to control the frequency and channel parameters of
the instrument.
Some features in the Frequency menu are the same for all measurements in the
current Mode – they do not change as you change measurements. Settings like
these are called “Meas Global” and are unaffected by "Meas Preset" on page 1917.
For example, Center Frequency is the same for all measurements — it does not
change as you change measurements.
3.11.6.1 Settings
Contains the basic Frequency functions.
Fundamental
Sets the frequency of the fundamental measured signal. By default, other harmonic
measurements will be measured at multiples of the specified fundamental
frequency.
If Auto is on, the fundamental is determined from the first sweep ("Harmonic
Measurement Details" on page 1849) whenever the measurement is restarted. If
Manual, the first sweep is still taken to determine the resolution bandwidth.
Remote Command
[:SENSe]:HARMonics:FREQuency:FUNDamental <freq>
[:SENSe]:HARMonics:FREQuency:FUNDamental?
Spectrum Analyzer Mode User's &Programmer's Reference 1907
To Next Page
Loading...
