38 U9361C/F/G/M RCal Measurement Guide
Making Measurements
Measuring Magnitude Cal with Multiple States
14. When the calibration is complete, select Apply and close the Calibration
Configuration window.
15. Disconnect the cable from the RCal module and connect it to the RF
output of the signal generator.
16. Select Meas Setup > Source tab > RF Output > On to enable the signal
generator output.
17. Verify the calibration by adding another trace.
Navigate to Trace > Select Trace > Trace 2
Set Trace Type to Max Hold and set View to Active
Wait for the trace to stabilize, then select View > View to store the
trace.
To Next Page
Loading...