EasyManua.ls Logo

Kia EV6 - Page 244

Kia EV6
506 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Driving your vehicle
366
All wheel drive (4WD)
4WD vehicles could change the
engagement status of the motor
according to the situation required.
Auto changing the driving mode
(2WD/4WD) helps improve energy
efficiency and driving stability.
僅When the vehicle is stuck in snow,
sand or mud, place a non-slip material
under the drive wheels to provide
traction OR slowly spin the wheels in
forward and reverse directions which
causes a rocking motion that may free
the vehicle.
When putting the tire chains to the
tire, be sure to attach the chain to the
two rear wheels. In this case, drive
below 30 km/h (20 mph) and mini
-
mize the driving distance. High-speed
or long-term driving with putting the
tire chains may cause malfunction or
damage to the four-wheel drive.
If tire chains must be used, use fabric
snow chain and install the tire chain
after reviewing the instructions pro
-
vided with the tire chains. For more
information on Snow Tires and Tire
Chains, refer to "Winter driving" on
page 6-190.
Emergency precautions
Tires
When replacing the tires, be sure to
equip all four tires with the tire and
wheel of the same size, type, tread,
brand and load-carrying capacity.
In case of emergency such as tire punc
-
ture, repair it using TMK (Tire Mobility
Kit) for temporary use. Afterwards, have
the tire be inspected by an authorized
Kia dealer/service partner.
Towing
4WD vehicles must be towed with a
wheel lift and dollies or flatbed equip
-
ment with all the wheels off the ground.
For more information, refer to "Towing"
on page 7-14.
Vehicle inspection
When the vehicle is on a car lift, do not
operate the front and rear wheels
separately. All four wheels should be
operated.
Never engage the parking brake while
running the vehicle on a car lift. This
may damage the 4WD system.
Dynamometer testing
A 4WD vehicle must be tested on a spe
-
cial four wheel chassis dynamometer.
If a 2WD roll tester must be used, per
-
form the following procedure.
A: Roll tester (Speedometer)
B: Temporary free roller
Operation
Check the tire pressures recom
-
mended for your vehicle.
Place the rear wheels on the roll tester
for a speedometer test as shown in
the illustration.
Release the parking brake.
Place the front wheels on the tempo
-
rary free roller as shown in the illustra
-
tion.
OCV061004L

Table of Contents

Other manuals for Kia EV6

Related product manuals