11
7
7
What to do in an emergency If you have a flat tire (with Tire Mobility Kit)
Using the Tire Mobility Kit
Operation
僅 Shake the sealant bottle.
僅 Remove the sealant bottle cap and
sealant bottle holder cap and screw
the bottle onto the sealant bottle
holder.
僅 Make sure the compressor valve on
the filling hose is locked.
僅 Unscrew the valve cap and screw the
filling hose onto the tire valve.
僅 Make sure the compressor is turned
off.
僅 Connect the power outlet connector.
僅 Start the vehicle.
僅 Turn the compressor on and let it run
for approximately 5~7 minutes to fill
the sealant up to the proper pressure.
僅 Turn the compressor off.
僅 Detach the filling hose from the tire
valve.
Distributing the sealant
Operation
僅 Immediately drive approximately
7~10 km (4~6 miles, or approximately
10 minutes) to distribute the tire seal
-
ant evenly.
僅 Do not leave your vehicle running in a
poorly ventilated area for extended
periods of time. Carbon monoxide
poisoning and suffocation can occur.
僅 If the tire pressure is below 26 psi(180
kPa), do not drive the vehicle. The tire
may cause accident.
To Next Page
Loading...
