Driving your vehicle
406
Forward Collision-Avoidance Assist (FCA)
Detecting sensor
Front view camera
Front radar
Front corner radar (if equipped)
Rear corner radar (if equipped)
Refer to the picture above for the
detailed location of the detecting sen
-
sors.
Take the following precautions to main
-
tain optimal performance of the detect
-
ing sensor:
僅 Never disassemble the detecting sen
-
sor or sensor assembly, or apply any
impact on it.
僅 If the detecting sensors have been
replaced or repaired, have the vehicle
inspected by a professional workshop.
Kia recommends visiting an autho
-
rized Kia dealer/service partner.
僅 Never install any accessories or stick
-
ers on the front windshield, or tint the
front windshield.
僅 Pay extreme caution to keep the front
view camera dry.
僅 Never place any reflective objects (i.e.
white paper, mirror) over the dash
-
board.
僅 Do not apply license plate frame or
objects, such as a bumper sticker, film
or a bumper guard, near the front
radar cover.
僅 Always keep the front radar and cover
clean and free of dirt and debris.
Use only a soft cloth to wash the vehi
-
cle. Do not spray pressurized water
directly on the sensor or sensor cover.
僅 If unnecessary force has been applied
to the radar or around the radar, For
-
ward Collision-Avoidance Assist may
not properly operate even though a
warning message does not appear on
the cluster. Have the vehicle
inspected by a professional workshop.
Kia recommends visiting an autho
-
rized Kia dealer/service partner.
僅 Use only genuine parts to repair or
replace a damaged front radar cover.
Do not apply paint to the front radar
cover.
To Next Page
Loading...
