Kia EV6 - Page 333

125
6
6
Driving your vehicle Highway Driving Assist (HDA)
Highway Lane Change Assist function
will be displayed as below depending on
the status of the function.
Ready/Operating
Standby/Canceled
1 Highway Lane Change Assist indicator
僅 Green ( ) on: Ready state
僅 Green ( ) blink: Operating state
僅 Grey ( ) on: Standby state
僅 White ( ) blink: Canceled state
(display only a certain time)
2 Lane line
The lane line is displayed identical to
Highway Lane Change Assist indicator
(1). However, the lane detection avail
-
ability will be showed on Standby
state.
3 Green arrow and shade
The green arrow is displayed when a
certain amount of time has passed
after the function has started operat
-
ing, and until the lane change has
completed.
4 Message
僅 Message is displayed when the
function does not operate even
though the turn signal lever is used.
僅 Message is displayed when the
function is canceled while operat -
ing.
To turn on Highway Lane Change
Assist
A: Press OK button to enable Lane
Change Assist
1 Confirm
Highway Lane Change Assist function
will turn on when the following condi
-
tions are satisfied.
僅 The Driving Assist button or Lane
Driving Assist button is used to turn
on Highway Driving Assist.
僅The OK button is pressed on the
steering wheel while a message ask
-
ing to use Highway Lane Change
Assist is displayed on the cluster.
Highway Lane Change Assist
ready to operate
While Highway Lane Change Assist
function is on, the function will be ready
to operate when all the following condi -
tions are satisfied:
僅 Highway Driving Assist is operating
僅 Lane Following Assist is operating
僅 A vehicle in the rear area of your vehi
-
cle is detected more than once after
the vehicle is turned on
僅 Your vehicle speed is above 80 km/h
(50 mph)
僅 Hands-off warning is not displayed on
the cluster
僅 Hazard warning flasher is off
OCV041263L
OCV051221L
OCV051210L