TIMING SYSTEM EMA -31
REASSEMBLY E0BF1C9F
1. The key(A) of crankshaft should be aligned with the
timing mark(B) of timing chain cover. As a result of
this, the piston of No.1 cylinder is placed at the top
dead center on compression stroke.
B
A
KDRF128A
2. Install tensioner adapter assembly(A).
A
KDRF127A
3. Install crankshaft sprocket(A)(LH camshaft drive).
A
KDRF126A
4. Install LH timing chain gu id e(A).
Tightening torque
19.60 ~ 24.50Nm(2.0 ~ 2.5kgf.m, 14.17 ~ 18.08lb-ft)
A
KDRF125A
5. Install L H timing ch ain .
To install the timing chain with no slack between each
shaft (cam, crank), follow the below p rocedure.
Cra
nkshaft sprocke t(A) → Timing chain guide(B) →
Exhaust camshaft sprocket(C) → Intake camshaft
sprocket(D).
The timing mark of each sprockets should be matched
with timing mark (color link) of timing cha in at installing
timing chain.
KDRF123B
6. Install LH timing chain tensioner ar m(B).
Tightening torque
18.62 ~ 21.56Nm(1.9 ~ 2.2kgf.m, 13.74 ~ 15.91lb-ft)
To Next Page
Loading...