CYLINDER HEAD ASSEMBLY EMA -51
NOTE
Always use new cylinder head bolt.
5
6237
8 4 1
7326
841
5
KDRF199B
A
ECBF035A
09221 - 4A000
KDRF223A
4. Install the CVVT and ca mshaft s p ro cket.
Tightening torque
64.68 ~ 76.44Nm(6.6 ~ 7.8 kgf.m, 47.74 ~ 56.4lb-ft)
KCRF122A
NOTE
• Install camshaft-inlet to dowel pin of CVVT as-
sembly .
At this tim e, a tten d not to be installed to oil h ole
of camshaft-inlet.
• Hold the hex agonal head wrench portion of the
camshaft with a vise, and install the bolt and
CVVT assembly.
• Do no t rotate CVVT assembly when camshaf t is
installedtodowelpinofCVVTassembly.
5. Install camshafts(A).
NOTE
• Apply a lig ht coat of eng ine oil on cam shaft jour-
nals.
• Assemble the key groove of camshaft rear side
to the same level of head top surface.
• Be careful the right, left bank, intake, exhaust
side before assembling.
A
KDRF197A
To Next Page
Loading...