EMA - 38 ENGINE MECHANICAL SYSTEM
INSTALLATION E0ED79CB
1. Install intake manifold.
2. Install water pump pulley(A).
Tightening torque
7.84 ~ 9.80N m(0.8 ~ 1.0k gf.m, 5.78 ~ 7.23lb-ft)
A
KDRF107A
3. Ins
tall drive belt auto tensioner(A).
Tightening torque
81.4 ~ 85.3N m(8.3 ~ 8.7kgf.m, 60.0 ~ 62.9lb-ft)
29.4 ~ 33.3N m(3.0 ~ 3.4kgf.m, 21.7 ~ 24.6lb-ft)
A
KDRF106A
4. Install drive belt idler(A).
Tightening torque
52.92 ~ 57.82Nm(5.4 ~ 5.9kgf.m, 39.06 ~ 42.67lb-ft)
A
KDR
F105A
5. Install alternator
6. Install air compressor
7. Ins
tall power steering pump.
8. Install drive belt(A).
Crankshaft pulley → A/C pulley → id le r pulley → alter-
nat
or pulley → water pump pulley → P/S pump pulley
→ tensioner pulley.
Rotate auto tensioner ar m in the counter - clockwise
moving auto tensioner pulley bolt with wrench.
After putting belt on auto tensioner pulley, release the
auto tensioner pulley slowly.
A
SBLM16101L
To Next Page
Loading...