EMA - 80 ENGINE MECHANICAL SYSTEM
B
SBLM16116L
6. Disconnect WTS connector.
7. Disconnect heater hose, water vent hose and water
hose from water temperature c ontrol assembly.
8. Remove the fuel pipe(A).
A
SBLM16015L
9. Remove water te mperature control a ssembly(A).
A
SBLM16204L
THERMOSTAT
NOTE
Removal of the thermostat would have an adverse
effect, causing a lowering of cooling efficiency. Do
not remove the thermostat, even if the engine tends
to overheat.
1. Drain engine coolant so its level is below thermostat.
2. Remove water inlet(A) and ther mostat(B).
A
B
SBLM16026L
To Next Page
Loading...