CYLINDER HEAD ASSEMBLY EMA -49
3. Install OCV(A).
Tightening torque
9.80 ~ 11.76Nm(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
A
KDR
F202A
NOTE
• To i
nstall OCV with gray colored connector into
RH b
ank.
• To i
nstall OCV with black colored connector into
LH b
ank.
CAUTION
• Do not reuse the OCV when dropped.
• Keep clean the OCV.
• Do not hold the OCV sleeve during servicing.
• When the OCV is installed on t he en gine, do
not move the engine with holding the OCV
yoke.
INSTALLATION E63A6A04
NOTE
• Thoroughly clean all parts to be assembled.
• Always use a new head and manifold gasket.
• The cylinder head gasket is a metal gasket. Take
care not to bend it.
• Rotate the crankshaft, set theNo.1 piston at TDC.
1. Install the cylinde r head.
a. The sealant locations on cylinder head and cylin-
der block must be free of engine oil and ETC.
b. Apply sealant on cylinder block top face before
assembling cylinder head gaskets.
The part must be assembled within 5 minutes
after sealant was applied.
15mm15mm
B
D
C
A
A
B
D
C
RH
BANK
LH
BANK
CYLNIDER
BLOCK
TOP FACE
(LH BANK)
CYLNIDER
BLOCK
TOP FACE
(RH BANK)
Engine Front Face
ECBF017A
To Next Page
Loading...