LUBRICATION SYSTEM EMA - 93
CAUTION
• Make clean the sealing face before assem-
bling two parts.
• Remove harmful foreign matters on the seal-
ing face before applying sealant
• When applying sealant gasket, sealant must
not be protruded into the inside of oil pan.
• To prevent leakage of oil, apply sealant gas-
ket ot the inner threads of the bolt holes.
e. Install upper oil pan.
Uniformly tighten the bolts in several passes.
Tightening torque
9.80 ~ 11.76Nm (1.0 ~ 1 .2kgf.m, 7.23 ~ 8.68lb-ft)
3
4 5
7
9 8
6 11 15
12 16 13
14 10 1
2
KDRF
131A
f. Install the front member.(Refer to Front suspen-
sion system in SS Group).
g. After assembly, wait at least 30 minutes before
filling the engine with oil.
OIL FILTE R ASSEMBLY
1. Install oil filter body and new O-rings.
Tightening torque
9.80 ~ 11.76Nm (1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
NOTE
• Allrub
ber gasket must be no damaged by assem-
bling p
arts.
• Be care
ful of the knock sensor connector.
• Always
use a new O-ring
2. Instal
l oil filter body cover(B) and new gasket on the
oil fil
ter body(A).
Tightening torque
9.80 ~ 11.76Nm (1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
A
B
SBLM16027L
3. Install the water temperature control assembly.
4. Connect the water hoses on the water temperature
control assembly.
5. Connect the oil pressure switch connector.
6. Install the intake manifold and surge tank.
7. Fill with engine coolant.
8. Star t engine and check for leaks.
9. Recheck engine coolant level.
To Next Page
Loading...