ENGINE BLOCK EMA -57
DISASSEMBLY EBCBF7FE
1. Rem ove drive pla te.
2. Remove knock sensor(A).
A
KDRF205A
3. Remove upper oil pan(A).
A
KDRF206A
4. Remove baffle plate(A).
A
KDRF207A
5. Remove rear oil seal case(A).
A
KDRF208A
6. Remove oil drain cover(A).
A
KDRF209A
7. Check the connecting rod end play.
8. Check the connecting rod oil clearance.
9. Remove p ist on and connecting rod assemblies.
1) Using a ridge reamer, remove all the carbon from
the top of the cylinder.
2) Push the piston, connecting rod assembly and
upper bearing through the top of the cylinder
block.
NOTE
• Keep the bearings, connecting rod and cap to-
gether.
• Arrange the piston and connecting rod assem-
blies in the correct order.
To Next Page
Loading...