ENGINE BLOCK EMA -69
5. Install thrust bearings.
Install the 2 thrust bearings(A) under the No.3 jour nal
position of the cylinder block with the oil grooves fac-
ing outward.
A
ECKD324A
6. Place crankshaft on the cylinder block.
A
KDRF210A
7. Place main bearing caps on cylinder block.
8. Install main bearing cap bolts.
1) Install and uniformly tighten the bearing cap
bolts, in several passes, in the sequence shown.
Tightening torque
Main be aring cap bolt
49.00Nm(5.0 kgf.m, 36.16lb-ft) + 90
(1 ~ 8)
19.60 Nm(2.0 kgf.m, 14.46lb-ft)+ 120
(9 ~ 16)
29.40 ~ 31.36Nm(3.0 ~ 3.2 kgf.m, 21.70 ~
23.14lb-ft) (17 ~ 22)
NOTE
• Always use new main bearing cap bolt.
• If any of the bearing cap bolts in broken or de-
formed, replace it.
9
1
2
10
13
5
6
14
12
4
3
11
16
18 17 19
222021
8
7
15
KDRF140A
Use SST( 09221-4A000 ), install main bearing
cap bolts.
09221 - 4A000
KDRF224A
2) Check that the crankshaft tur ns smoothly.
9. Check crankshaft end play.
10. Install piston and connecting rod assemblies.
NOTE
Before installing the pistons, a pply a coa t of engine oil
to the ring grooves and cylinder bores.
1
)
I
nstall the r ing compressor, check that the bear-
i
ng is securely in place, then position the piston in
t
he cylinder, and tap it in using the wooden han-
dle of a hammer.
To Next Page
Loading...