TM0024 Page 13 of 33 Issue 2.01
Reset
Operation of the Reset membrane key is only permissible at access levels 2. When
operated any activation, which is existing, on the control panel will be cleared and
Status Normal will be reinstated.
Delay Override
The operation of the Delay Override is permissible at access levels 1 and 2 and will,
when operated override the operation of any time delays which have been
programmed to the panel (timers 1, 2 and 3). When operated a confirmation
message will be displayed and the relevant countdown timer will then be cancelled.
Evacuate
Operation of the Evacuate membrane key is only accessible at access levels 2.
When the evacuate membrane key is operated the sounder circuits and other outputs
which are programmed to operate will activate. The display will have a confirmation
message of the operation as shown in figure 2.6.
EVACUATE
Access Level 2
Press 0 - 9 for menus
figure 2.6
When in the Evacuate mode the output operation will remain until the Silence Alarms
membrane key has been operated. Operation of the Evacuate membrane key while
a priority alarm has been activated, will cause the display to confirm the operation as
shown in figure 2.7, which will remain until the silence alarm key has been operated.
FIRE
MANUAL EVACUATE
Total 001
1st Z010 Production area
Operate
←
to list devices
To Next Page
Loading...