TM0024 Page 19 of 33 Issue 2.01
Device Range
When Selected the display will request for a loop, start device and end device
number to be selected as shown in figure 3.7.
Access level 2 Isolate
Device range information
Loop _1 Start _ _1 End _ 10
Isolate De-isolate
Enter information then operate
↵
Figure 3.7
Once entered a choice of “ISOLATE” or “DE-ISOLATE” is requested, by operation of
the arrow keys the required option can be selected. The selection of either option will
not depend upon the current status of the device i.e. if devices are already isolated
and the “isolate” option is made the devices will remain isolated. Isolation of a
device(s) will illuminate both the Device Isolated and the Common Isolate LED.
If the isolation of a range of devices covers a full zone then the relevant zonal led will
be illuminated, if however the selection does not cover a full zone then the device
isolate led will be illuminated. Operation of the isolate procedure will cause the
common isolate led to illuminate. Operation of the Cancel key will return the display
through the menu selections and continued operation will return the panel to access
level 1, where the display will show a devices isolated message as shown in figure
3.3.
To Next Page
Loading...