PMC-A 73
6
Maintenance
■ Ammeter at full scale
11.
Set the output current (a value calculated from the
external DVM reading and shunt resistance) to the
rated current.
12.
Adjust I METER FS so that the ammeter reading on
the power supply is equal to the rated current.
Type I: Variable resistor 2
Type II: Variable resistor 5
■ Preset current indicator at full scale (Type I model
only)
13.
Adjust I LIMIT FS so that the ammeter reading on the
power supply is equal to the value calculated from
the external DVM reading and shunt resistance when
the LIMIT switch is pressed while delivering rated
current.
Type I: Variable resistor 5
To Next Page
Loading...
