TERRA 4K Operation Manual（KineOS 6.2）
©2019 Kinefinity Inc. Page 28 / 60
3.5 Firmware Update and Option Upgrade
Updating firmware is easy and quick: download firmware from Kinefinity
website, prepare a USB thumb as FAT32. Besides, you can also downgrade to
the previous firmware version.
3.5.1 Firmware Update
The firmware version is shown at the bottom of Configuration menu, for
example, firmware: KineOS V6.2 (02), means KineOS version is 6.2 with
building number of 6202. Upgrade the firmware as following steps:
1. Download: Download the latest firmware, and copy it to the root
folder of a FAT32 USB disk; insert the USB disk into USB socket of
TERRA; there will be an USB label in the UI;
2. Update: do [ConfigurationSystemUpdate Firmware]. Confirm to
upgrade, wait about fifteen minutes till the successful display comes
out;
3. Reboot: Power down, and get USB disk out. Power on, and then the
new firmware takes effective.
If the camera shows the USB information but cannot update the firmware,
please refer to TERRA FAQ.
CAUTION Do NOT take any other operation and Never lose power when
update firmware, else it may lead to failure of firmware update,
even camera has to be sent to Kinefinity for repair.
CAUTION Remove any lenses before updating the firmware.
NOTE It is highly recommended that user should restore to factory
settings and do black balancing after the update.
Menu Operation
Update Firmware
[ConfigurationSystem
Update Firmware]
To Next Page
Loading...