TERRA 4K Operation Manual（KineOS 6.2）
©2019 Kinefinity Inc. Page 32 / 60
3.7 Configure Camera
You can save settings to the camera: preset list, body fan speed, EI/ISO
mode, shutter mode, etc. When power on with USB disk, the camera will do
factory reset.
3.7.1 Preset
In-Camera Presets are a set of parameters for recording and shooting:
Image Format; Resolution; FPS; Shutter Speed; Record Format
Moreover, there are eight in-camera presets, and it provides quick switch for
these presets: [<] button to pop up the Preset Shortcut list.
Besides, customers can define and save these in-camera presets. After setting
these parameters in Liveview state, then:
[ConfigurationShootingSave as Preset]
You will find the preset you save on the list.
3.7.2 Shutter Display Mode
There are two modes for shutter display: Shutter Speed and Shutter Angle:
[ConfigurationLiveviewShutter Mode: Time/Angle]
Calculation between Speed and Angle, if Shutter Speed is 1/50s, and fps is
25, and then the shutter angle is:
25*360*(1/50) = 180 Degree.
The Shutter Angle of TERRA ranges from 0.7~358 Degree; the Shutter Speed
has min value 1/2000, and the max value depends on the FPS.
Besides, Shutter Speed List does NOT match Shutter Angle List.
NOTE Set appropriate shutter speed to avoid flickering: for example,
1/50s, or 172.8 Degree.
Menu Operation
Change Shutter Display
[Configuration
LiveviewShutter Mode:
Time/Angle]
Menu Operation
Change Presets
[ConfigurationShooting
Save as Preset]
To Next Page
Loading...