Installation / Mounting
Issue: 08/2012
U A water ow of 2 to 3 l/min is needed to get a water temperature of 18° C ± 2° C
(64° F ± 10° F).
U The water temperature should not be less than 16° C, otherwise water can con-
dense on pipes, cables and lm running components and nally results in damage
of the lm material. At bad conditions dropping water can damage the electronics.
U If possible the heat exchanger must not have more than 10 m distance to projector
and refrigerating set must not have more than 15 m distance to heat exchanger.
If environment temperature is high and wires are long, the hose is to be isolated
because of condensation water.
U At bad climatic conditions (high temperature, high humidity) condensation can also
occur above 16° C - in this case please check the projector.
• Connect the inlet and outlet tubes of
the water cooling system to the con-
necting pieces in the projector.
X
You will nd the description of the
water cooling unit in the corresponding
operating manual.
To Next Page
Loading...
