CK20(H)
2
S196-WOO Jul. 2003
SAFETY STARTING
1. Always use the safety start switch to start the en-
gine and never by any other means.
2. Do not alter or remove any part of machine safety
system.
3. Before starting the engine, make sure that all shift
levers are in neutral positions or in disengaged
positions.
4. Never start the engine unless you are in the
operator’s seat.
196W002A
This symbol, the industry’s “Safety Alert Symbol”, is used throughout this manual and the decals on the machine
itself to warn of the possibility of personal injury. It is essential that you read the instructions and safety regulations
before you attempt to repair or operate this unit. Read these instructions carefully.
SAFETY FIRST
SIGNS
DANGER
WARNING
CAUTION
IMPORTANT
DESCRIPTION
This mark indicates hazardous situation which, if not observed, may
result in death or fatal injury.
This mark should be indicated for most dangerous situations only.
This mark indicates potentially hazardous situation which, if not
observed, may result in death or moderate injury.
This mark indicates potentially hazardous situation which, if not
observed, may result in minor or moderate injury. And this mark can be
used as a warning against unsafe activities.
This mark indicates emphasis on notable characteristics in working
procedures or information on working procedures and technology for
convenient use.
NOTE
Gives helpful information.
BEFORE SERVICING AND REPAIRING
1. Read all safety instructions in this manual and be
aware of the safety decals on your machine itself.
2. Thoroughly clean your work area and the machine.
3. Make sure the machine is on firm and level ground
and that the parking brake is set.
4. Lower the implement to the ground.
5. Stop the engine and remove the key.
6. Disconnect the negative battery cable.
7. Place a “DO NOT OPERATE” tag in operator station.
196W001A
To Next Page
Loading...
Need help?
General
