GENERAL
1-21
S196-WOO Jul. 2003
9.3 EVERY 100 HOURS
A. CHANGING ENGINE OIL
(1) Oil Inlet
(2) Dipstick
(A) Oil Level is Acceptable Within this Range
196W125A
(1) Drain Plug
1. To drain the used oil, remove the drain plug at the
bottom of the engine and drain the oil completely
into the oil pan.
All the used oil can be drained out easily when the
engine is still warm.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper notch on the
dipstick.
Oil capacity
with filter
CH20H
CK20
2.6
(0.69 U.S.gal.)
196W126A
B. CHECKING FUEL LINE
1. Check to see that all lines and hose clamps are
tight and not damaged.
2. If hoses and clamps are found worn or damaged,
replace or repair them at once.
NOTE:
• If the fuel line is removed, be sure to properly bleed
the fuel system. (See “Bleeding Fuel System” in as
required maintenance)
(1) Fuel Lines (2) Clamp Bands
196W131A
To avoid personal injury:
• Be sure to stop the engine before changing the oil.
• Allow engine to cool down sufficiently, oil can be
hot and can burn.
CAUTION
To Next Page
Loading...
