Kirsch Roller & Screen Shade - Care and Maintenance; Removing the Shade; Cassette Removal; Cleaning Procedures

32
INSTALLATION
CARE
Removing the Shade
CAUTION: Before removing the shade, the shade should be fully raised.
■
Pocket Shades Only. Remove the bottom cover. Lift up the edge of the bottom cover. Disengage it from the
ledge of thepocket.
■
Fascia Shades Only. Remove the front/bottom cover of the fascia by pulling down on the bottom of the
cover, near the installation brackets, to release it from the tabs on the installationbrackets.
➤
Rotate the cover up and removeit.
■
Standard Bracket Shades with Bracket Covers. Remove the cover on the motor-side.
NOTE: Standard Bracket shades are shown in the illustration, but the process is the same for all shades types except Cassette
shades shown below.
■
Disconnect power and make sure cables are not caught before attempting to removing shade.
■
You will use a screwdriver to push the latch. First, push the shade away from the screwdriver until
the latch moves (depending on your mounting type you may need to push up or in), and then press
the latch.
■
Slide the shade out of the motor bracket.
■
Pull the shade from the idle bracket.
Cassette Removal
■
Move the shade to the fully raised position and disconnect the power.
■
While keeping one hand on the cassette at all times, push up on the plastic release tabs of the cassette bracket on the end until
you hear it click and see that it stays in place.
NOTE: Push up on the release tabs of the end brackets first and then on the center bracket(s).
■
Place both hands in the middle of the cassette (along the front bottom) and pull straight out.
Cleaning Procedures
Kirsch® shades are made from dust-resistant materials which repel dirt and dust. The following options are available if your shade
needs cleaning.
Dusting
■
Regular light dusting with a feather duster is all the cleaning needed in most circumstances.
Vacuuming
■
Use a hand-held vacuum with low suction for more thorough dust removal.
Compressed Air/Hair Dryer (Cool Setting)
■
Use compressed air or a hair-dryer on a cool setting to blow dust and dirt off of shades.
Fascia
Panel
Pull Down
to Release
Push
Up on
Shade
Inside Mount
Outside Mount
Push
Latch with
Screwdriver
Push
In on
Shade
Push
Latch with
Screwdriver
Bracket
Cassette
Release Tab
Bracket