Kirsch Roller & Screen Shade - STEP 3: Install the Shade; General Shade Installation Overview

18
INSTALLATION
INSTALLATION
STEP 3: Install the Shade
Standard, Fascia, Pocket and Dual Roller Bracket Shades
Your shade may be standard roll or reverse roll based on your order. For dual roller shades, you will have one of each. Be sure to
orient the shade correctly before installing.
■
Remove the foam insert from the idle end of the shade.
■
Verify the top limit screw is screwed in completely. The screw will tighten counterclockwise for
standard roll and clockwise for reverse roll.
■
The shade should be wrapped tight with the paper banding in place. The bottom bar should be
positioned just below the fabric in either the standard or reverse roll position based on your order.
Wall or
Window
Room
Wall or
Window
Room
Standard Roll
Note: Shade are lowered for clarity. The shade should be wrapped tight with the paper banding in place.
Reverse Roll
Remove
Foam
Insert
Top
Limit
Screw
Reverse Roll
Standard Roll
Standard Roll
Bottom
Bar
Paper
Banding
Tube and
Shade
Fabric
Reverse Roll