Kirsch Roller & Screen Shade - Fascia Shades Installation

11
INSTALLATION
INSTALLATION
Fascia Shades
■
Assemble the two end brackets and
the fascia panel.
➤
Place the top of the fascia panel into the top indention of the brackets. Rotate the panel
down and snap it into place.
IMPORTANT: Check that the outer surfaces of the brackets are flush with the ends of the
panel.
■
Center the bracket and panel assembly over the window at the desired height.
➤
Use a level against the bottom edge to make sure the assembly is level. Inside
mounts may require a shim between the brackets and the mountingsurface.
■
For Outside Mount. Use a pencil to mark the bottom and outside edges of the
brackets on the mountingsurface.
■
For Inside Mount. Use a pencil to mark the outside edges of the brackets on the
mountingsurface.
■
Remove the assembly from the window.
■
Remove the brackets from the fascia panel.
■
Outside Mount. Use your marks to position each bracket and mark each of the
screw holes.
➤
For 4” Fascia, a minimum of 4
1
⁄ 8 ” flat vertical surface is required to mount the
brackets.
➤
For 3” Fascia, a minimum of 3” flat vertical surface is required to mount the
brackets.
➤
The top of the installation brackets should be at the desired height. Use your marks to position each bracket and mark the
screw holes.
IMPORTANT: The brackets should be level and aligned.
Fascia
Panel
Pencil Marks
(Outside Mount)
Pencil Marks
(Inside Mount)
Outer Surface
of the Bracket
Flush with the
Ends of the Panel