3-2
Tones
Tones are audible signals, indicating the
following:
One Long Beep
Activation/deactivation of the Cooktop Lock •
function
Three Short Beeps
Invalid operation - attempting to lock or unlock •
cooktop with 1 or more burners are on.
Hot Surface Indicator Light
The Hot Surface Indicator Light is located be-
tween the left front and center control knobs.
The Hot Surface Indicator Light will glow as
long as any surface cooking area is too hot to
touch, even after the surface cooking area(s)
is turn off. If the cooktop is on when a power
failure occurs, the Hot Surface Indicator Lights
will remain on after the power is restored to the
cooktop. They will remain on until the cooktop
has cooled completely.
After a power failure, when the power failure
is restored the Hot Surface Indicator Light can
stay on for up to 30 minutes
Times when this is most likely to occur:
After the cooktop is rst installed.•
After a power failure.•
After a power failure while the cooktop is still •
cooling (30 to 40 minutes after cooking).
Any time power is disconnected from the •
cooktop.
Power Failure
Cooktop will not operate during a power
failure. (Models KFGU Only)
To Light:
1. Push in and turn knob counterclockwise to
LITE. All surface burners will click. Only the
burner with the control knob turned to Lite
will produce a ame.
2. Turn knob to anywhere between HI and LO.
Use the following chart as a guide when set-
ting heat levels.
SETTINGRECOMMENDED USE
Lite
Light the burner.
Hi
Start food cooking.
Bring liquid to a boil.
Medium
Between Hi and Lo
Fry or sauté foods.
Maintain a slow boil.
Cook soups, sauces and gravies.
Stew or steam foods.
Simmer
Simmer
Lo
Keep food warm.
REMEMBER: When cooktop is in use, the entire cooktop
area may become hot.
To Next Page
Loading...
