KitchenAid KFGS306VSS - Convert from Lp Gas to Natural Gas

2-16
IMPORTANT: The igniter electrode is ceramic
and could break during conversion. Be sure
that the electrode comes through the hole
in the burner head smoothly while tightening
screws.
A. Burner cap
B. Electrode
C. Burner base
B
C
A
16. Open shutoff valve in the gas supply line.
The valve is open when the handle is par-
allel to the gas pipe.
17. Plug in cooktop or reconnect power.
18. Adjust single and dual valve according to
"Flame Height Adjustment" section.
REMEMBER: Once you have completed
converting all the cooktop burners, test the
cooktop for leaks by brushing on an approved
noncorrosive leak-detection solution. Bubbles
will show, indicating a leak. Correct any leaks
found.
Convert from LP Gas to Natural Gas
1. Turn manual shutoff valve to the closed
position.
2. Unplug cooktop or disconnect power.
3. Determine the type of regulator you
have:
Style 1: The cap has a slot and “LP” printed
on it.
Remove access cap by using a at-blade
screwdriver or coin, turning the access cap
counterclockwise.
The gas pressure regulator has 2 settings
which are stamped on either side of the cap.
Turn the cap and reinstall into regulator with
the stamp “NAT” visible from the outside of the
regulator.
NAT
Style 2: The cap does not have a slot and
requires a wrench to be removed.
Remove the access cap by using a wrench,
turning the access cap counterclockwise.
Remove spring retainer from the cap by push-
ingagainsttheatsideofthespringretainer.
Look at the spring retainer to locate the “LP”
or “NAT” position. Turn over the spring retainer
so the “NAT” is showing on the bottom. Snap
the spring retainer back into the cap. Reinstall
the cap onto the regulator.
A. Access cap
B. Gasket
C. Gas pressure regulator
D. NAT position
E. LP position
A
B
CDE
4. If they are installed, remove the burner
grates.